do the saber and astro saber use the same programming cable

The firmware version appears in the center of the LCD display. You can check the firmware version of your TS-590SG by accessing Menu No.00. You can find the serial number imprinted on the rear panel, just below the ANT1 or ANT2 connector it consists of an 8-digit number beginning with 'S/NO.' Serial numbers: From S/NO.B4Axxxxx through S/NO.C03xxxxx approx. The firmware updating program is applicable for following models/units. Updated items : (Version 1.00 1.01) Įnables output of the 475kHz band (472~479kHz) signal from the rear panel DRV (drive output) connector as well as 135kHz band.Īfter changing the operating mode, DATA VOX might not work correctly. (Please also update both of the Radio Control Program ARCP-590G and the Radio Host Program ARHP-590G for functional compatibility.) Adjust the Noise Blanker level once the Noise Blanker is set to OFF and NB1 or NB2 is set to ON. When NB1 and NB2 is set to ON at the same time, the Noise Blanker level cannot be adjusted. Then, pressing the key again enables NB1 and NB2 to be set to OFF. When the Noise Blanker is set to OFF, pressing and holding the key enables NB1 and NB2 to be set to ON at the same time. Updated item : (Version 1.01 1.02) Įnables NB1 and NB2 to be simultaneously set to ON. Updated item : (Version 1.02 1.03) Īfter changing the operating mode, the Split-frequency function might not work correctly. The internal antenna tuner may not work correctly under certain conditions. (Please also update the Radio Control Program ARCP-590G for functional compatibility.) The TS-590SG works as either 'TX/RX End' or 'Sub-receiver'.įor details, please refer to the revised TS-590SG Instruction Manuals. Updated item : (Version 1.04 1.05) Īdds 'Split Transfer A' function as well as the TS-890S.

Updated item : (Version 1.05 1.06) Īpplies electrical compatibility with new component devices as well as discontinued component devices. When connected to another transceiver for Split Transfer operation, the power may not be turned off correctly depending on the timing. Revises the expanded memory channels (E0~E4) default values according to the band plan.(K-type for USA and Canada only) The firmware updating program is not applicable for the TS-590S.Ī virtual COM port driver needs to be installed onto the PC to use the firmware updating program with a USB cable.ĪTTENTION:Do not connect the transceiver to a PC using a USB cable before installing the virtual COM port driver. You can update the TS-590SG firmware by connecting the TS-590SG to the PC by using a USB cable or an RS-232C cable.

We are offering the firmware updating program to the TS-590SG owners. The HF/50MHz All-mode transceiver TS-590SG firmware has been updated from Version 1.06 to Version 1.07 as follows.

Do the saber and astro saber use the same programming cable